Using GCxGC to see MOSH and MOAH

Pegasus Two-Dimensional Gas ChromatographFood contamination by mineral oil hydrocarbons (MOH), which is usually separated into the subclasses of MOSH (Mineral Oil Saturated Hydrocarbons) and MOAH (Mineral Oil Aromatic Hydrocarbons), is a growing concern across the EU and the world. In 2012, the European Food Safety Authority flagged them as a potential health concern, and the increasing research since then has only been expanding our understanding of these hydrocarbons.

The two main analytical methods suggested to quantify these substances, either an off-line method consisting of a solid phase extraction (SPE) followed by a GC-FID analysis or an on-line, LC-GC-FID method, both can result in inaccuracies and leads to challenges in the end results. Some of these inaccuracies are due to the lack of a strong and robust confirmatory method. However, a GCxGC-TOFMS system, like LECO’s Pegasus® BT 4D can help unveil the complexity of contaminated food samples. It has also been suggested by the EFSA to be used as a confirmatory tool in case of uncertain results from other standard methods.

Part of the struggle with identifying MOSH and MOAH contamination in food samples is the difficulty in separating the MOSH from the POSH (Polyolefin Oligomeric Saturated Hydrocarbons) and/or MOAH from biogenic substances such as terpenoids. The similarities in responses between these compounds can result in erroneous results, as non-contaminated samples may be incorrectly reported as contaminated. The extraordinary resolution power of the Pegasus BT 4D, however, allows these groups to be properly identified and differentiated.

LECO’s applications team ran an example workflow on a cumin extract to demonstrate the resolving power of the Pegasus BT 4D.

A previous analysis on a standard petroleum sample spiked with the MOSH/MOAH International Standard (Restek Coroporation, #31070), using the same procedure, was used to establish a reference for MOSH and MOAH compounds.

MOSH/MOAH Chromatogram
GCxGC-TOFMS contour plot from the VGO sample + the MOSH/MOAH internal standards (VGO-IS).

Following the analysis of the reference sample, the same method was used to analyze the cumin extract.

One type of compound screened for in the cumin extract was hopanes, which are regarded as confirmation of mineral oil contamination, but which are usually found in such trace amounts that they are difficult to separate and detect with the more traditional LC-GC-FID methodology. The Pegasus BT 4D found clear resolution and characteristic patterns of elution of the hopanes.

 

MOSH Hopanes Chart
Hopanes detection in the cumin MOSH fraction (m/z 191.21)

Learn more about how these results were obtained, the full results from the analysis, and the methodology used in our latest application note.

Jméno(Required)
This field is for validation purposes and should be left unchanged.